Location: <WorkspaceDirectory>\ConfigFiles\nxaOPCRouter.35.cfg
The following parameters are only relevant for KNXnet/IP devices:
...
Parameter
...
NETIP.ServerReceivePort
...
Description
...
Here the local UDP port for incoming KNXnet/IP tunnelling telegrams can be specified.
...
Scope
...
0 - 65535
...
Unit
...
None
...
Default value
...
20146
...
Parameter
...
NETIP.ServerSendPort
...
Description
...
Here the local UDP port for outgoing KNXnet/IP tunnelling telegrams can be specified.
...
Scope
...
0 - 65535
...
Unit
...
None
...
Default value
...
20146
...
Parameter
Description
.
Unit
Parameter
Description
-
-
Default value
| Parameter | Description | Scope | Unit | Default value |
|---|---|---|---|---|
| NETIP.NetworkCardIPAddress |
| The IP address of the local network interface used for KNX communication. If left empty, the BMS Server attempts to determine a suitable network interface based on local IP addresses and network masks combined with the interface's IP address. If the BMS Server is unable to find a suitable interface, an error message is raised |
Scope
| IP address |
| None |
Default value
| The IP address of the network interface for KNX communication. |
| NETIP.NAT |
This parameter specifies whether the KNXnet/IP device is behind a NAT router or firewall.
|
|
|
Scope
| ON, OFF |
Unit
| None |
| OFF |
...
| NETIP_ROUTING.NetworkCardIPAddress | The IP address of the network card used for KNXnet/IP routing. | IP address | None |