Versions Compared

Old Version 5

changes.mady.by.user Nahel Falhout (Unlicensed)

Saved on

compared with

New Version Current

changes.mady.by.user Wolfgang Granzer

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Location:


<WorkspaceDirectory>\DataFiles\nxaDeviceDefinitions.35.dat


The KNX device manager can check the availability of KNX devices. It tries to connect to the defined devices to verify whether they can be reached or not. If the connection fails, the value of the corresponding server item of the device is set to false. This feature is mainly used to check the availability for important devices. Note that the monitoring of KNX devices consumes network bandwidth within the KNX network, so it should only be used when necessary. Note that the telegrams that are used to verify the availability of KNX devices are not group telegrams and so they are not shown in the telegram monitor.

Info
! The system parameter "SYS.EnableDeviceManager" has to be set to "ON".


Info

! This definition file can also be generated using the ETS app import wizard (Studio → KNX → Inport NETx ETS App file ...) which generates the KNX device definitions from an exported ETS project.

The device definition file specifies all the devices that shall be checked. The structure of this file is as follows: 


'Syntax of the Device Definition Table:
'physical KNX Address;IP Address Name of Gateway;Polling interval (sec);Description;Alias '
1.1.1;192.168.1.7Router1;20;Device 1;Switch 1
1.1.2;192.168.1.8Router2;40;Device 2;


Each line – except comment lines that start with ' – defines a single KNX device.

 






    
1Physical KNX Address 
This attribute specifies the physical KNX Address of the device which shall be monitored.
2IP Address Name of Gateway 
This attribute defines the IP address name of the gateway via the device is reachable. "BROADCAST" is not supported in this case.
3Polling interval 
This attribute defines the polling interval in seconds.
4Description 
This attribute can be used to specify a human-readable text that further describes the device (can be any user-defined string).5Alias It defines an alias name for the server item that represents the KNX device. This alias is shown within the server item tree under the sub tree "Alias" .