...
The following parameters are only relevant for KNXnet/IP devices:
| Parameter | Description | Scope | Unit | Default value |
|---|---|---|---|---|
| NETIP.NetworkCardIPAddress |
| The IP address of the local network interface used for KNX communication. If left empty, the BMS Server attempts to determine a suitable network interface based on local IP addresses and network masks combined with the interface's IP address. If the BMS Server is unable to find a suitable interface, an error message is raised |
| IP address |
| None |
Default value
| The IP address of the network interface for KNX communication. |
| NETIP.NAT |
This parameter specifies whether the KNXnet/IP device is behind a NAT router or firewall.
|
|
|
| ON, OFF |
| None |
| OFF |
...
Parameter
ServerReceivePort
| NETIP_ROUTING. |
Description
Here the local UDP port for incoming KNXnet/IP tunnelling telegrams can be specified.
Scope
0 - 65535
Unit
None
Default value
20146
Parameter
NETIP.ServerSendPort
Description
Here the local UDP port for outgoing KNXnet/IP tunnelling telegrams can be specified.
Scope
0 - 65535
Unit
None
Default value
20146
...
| NetworkCardIPAddress | The IP address of the network card used for KNXnet/IP routing. | IP address | None |