/
KNX configuration

KNX configuration

Owned by dominik.kurfner (Unlicensed)

Location: <WorkspaceDirectory>\ConfigFiles\nxaOPCRouter.35.cfg

The following parameters are relevant for KNXnet/IP devices:

ParameterDescriptionScopeUnitDefault value
NETIP.NetworkCardIPAddressThe IP address of the local network interface used for KNX communication. If left empty, the BMS Server attempts to determine a suitable network interface based on local IP addresses and network masks combined with the interface's IP address. If the BMS Server is unable to find a suitable interface, an error message is raisedIP addressNoneThe IP address of the network interface for KNX communication.
NETIP.NAT

This parameter specifies whether the KNXnet/IP device is behind a NAT router or firewall.

  • ON: the NAT flag within the KNXnet/IP tunneling protocol is set.
  • OFF: the NAT flag is not set.
ON, OFFNoneOFF
NETIP_ROUTING.NetworkCardIPAddressThe IP address of the network card used for KNXnet/IP routing.IP addressNone


Related content