TODO:
KNX.PhysicalDeviceRetryCount
is das absichtlich rausgefallen?
reinhard [10:41 AM]
checking....
wgranzer [10:42 AM]
der parameter is im Jänner 2017 im BMS 2 hinzugekommen. kann sein dass das HCF damals nicht im BMS 4 aktualisiert wurde
Location: <WorkspaceDirectory>\ConfigFiles\nxaOPCRouter.35.cfg
The following parameters are only relevant for KNXnet/IP devices:
Parameter | NETIP.NetworkCardIPAddress |
|---|---|
Description | The IP address of the local network interface used for KNX communication. If left empty, the BMS Server attempts to determine a suitable network interface based on local IP addresses and network masks combined with the interface's IP address. If the BMS Server is unable to find a suitable interface, an error message is raised. |
Scope | IP address |
Unit | None |
Default value | IP address of the network interface for KNX communication. |
Parameter | NETIP.NAT |
|---|---|
Description | This parameter specifies whether the KNXnet/IP device is behind a NAT router or firewall. ON - the NAT flag within the KNXnet/IP tunneling protocol is set. OFF - the NAT flag is not set. |
Scope | ON, OFF |
Unit | None |
Default value | OFF |
TODO : Parameter exist ?
Parameter | NETIP.ServerReceivePort |
|---|---|
Description | Here the local UDP port for incoming KNXnet/IP tunnelling telegrams can be specified. |
Scope | 0 - 65535 |
Unit | None |
Default value | 20146 |
Parameter | NETIP.ServerSendPort |
|---|---|
Description | Here the local UDP port for outgoing KNXnet/IP tunnelling telegrams can be specified. |
Scope | 0 - 65535 |
Unit | None |
Default value | 20146 |