Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

Consider the following configuration. Within the room control unit relay 1 - 3 is activated. Each relay is linked to 1 group address. Within this example the KNX group address 1/1/1 - 1/1/3 where chosen.

As next, the configuration has to be export to Excel. To achieve this, press the button "Export to Excel ...":

The exported Excel has the following format:

NameObject functionDevice namePathComm flagRead flagWrite flagTransm flagUpdate flagInit-read flagPhysical adr.ReservedGroup addressesType informationData type
If bus voltage recovery,contact is>=0(unchange)switch_1_switch(Device name)
TTTTF
10.10.1
1.1.1
1Bi
If bus voltage recovery,contact is>=0(unchange)switch_2_switch(Device name)
TTTTF
10.10.1
1.1.2
1Bi
If bus voltage recovery,contact is>=0(unchange)switch_3_switch(Device name)
TTTTF
10.10.1
1.1.3
1Bi

This export format has to converted to the KNX Telegram Definitions that our NETx BMS Platform or NETx MP Server is using. In addition, the KNXnet/IP router or interface that is used by our server to connect to the KNX network has to be defined.

To achieve this, open the KNX gateway definition within the Core Studio of the NETx BMS Platform or NETx MP Server:

Within the definition table, add a new definition the enter the IP address, the port number, the type and the name. The name can freely be chosen:

Afterwards, open the KNX telegram definition:

Each definition corresponds to 1 KNX group address that shall be used within our server. To used group address 1/1/1 of relay 1 of our room control unit, the following entry has to be added:

KNX grp. adr. is the group address that was configured for the relay. KNX gateway name must correspond to the name that was chosen in KNX gateway definition. Priority is normally LOW. Data size and data type depends on the data point of the room control unit. Description can freely be chosen.

If multiple KNX group addresses shall be defined, you can also 




  • No labels